Airsoft Weapon Builds


G3A3ZF Wellsinator united states
(Classic Army) FPS: 552 RPS: ~18
Gearbox: Lonex (8mm Bushings)
Bushing Brand: Matrix
Spring: PDI 300%
Gears: Prometheus helicals
Motor: JG M42
Cylinder: CA
Cylinder Head: CA
Piston: Matrix
Piston Head: Speed airsoft
Nozzle: CA
Tappet Plate: CA
Spring Guide: Guarder
ARL: Lonex
Mods: compression mods,cylinder radiusing,blah,blah.blah

Barrel & Hopup
Barrel: EDGI
Length: Stock
Diameter: 6.05
Hopup: CA
Bucking: Lonex red
Nub: custom
Mods: home made flathop,bucking sealing,barrel polishing,hopup shimming etc
Real deal HK dead tree furniture,HK ejection port buffer,HK carry handle,sling,muzzle break,scope mount,leapers STANAG scope

Battery: lipo 11.1V 1800MAH 25c
Battery Location: Buttstock
Mosfet: ASCU fire controller
Added March 17th, 2013

G3 Tactical
G3 Swordfish
Troy M14 MCS
Rheinmetall MG3KWS
G3 Full Custom

Wellsinator says... March 30, 2013, 1:30AM
The receiver and cocking tube is actually wider on a CA than the real deal HK or Cetme.
This being said,both the port buffer and carry handle have to be installed with some effort.Thankfully because of this,there is little chance of them comming off.

blackswift says... March 30, 2013, 7:01AM
Okay, yeah, I left that part out. On mine, I should post soon. I had to channel out the fore grip. However the stock fit on there with minimal effort. RTG had the combination of the carry handle and port buffer but it seems they are out of the buffer. I'm debating placing an order for at least the carry handle for now. It looks very neat, yours, decked out.

Wellsinator says... March 30, 2013, 11:01PM
I was actually thinking about that after I posted.I milled the handguard a bit on mine aswell.On the inside where it mates up to the upper receiver.


© 2019 | contact us | disclaimer